Difference between revisions of "Lava Lagoon Warpless"
(→Safe) |
(→Optimal) |
||
| (19 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
===Optimal=== | ===Optimal=== | ||
| − | {{#ev:youtube| | + | {{#ev:youtube|1pA-R4YDPD0|560||https://youtu.be/1pA-R4YDPD0}} |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | + | *Try your best to cut corners as with all water stages. | |
| + | *Klampon bounce; You need to roll very close to the edge of the platform, jump out of it as late as you dare and do a full jump. It's recommended to briefly let go and repress the d-pad right after the bounce to not go straight into the lava. An easier method is shown below. | ||
| + | *0:13; Face left while exiting the water to spawn the klampon later so you can jump over it. an easier method is shown below. | ||
| + | *0:23; don't buffer this roll, you could miss clapper and take damage. | ||
| + | *0:31 try to avoid grabbing half-way, it causes a lot of lag, the roll over the gap right after can't be buffered. | ||
| + | *0:40 try staying close to the surface on the ascend here. The Lockjaw's spawn position depends on the water level and kong's position. By staying close to the surface you can cut the corner a bit tighter. | ||
| + | *0:50 wiggle down the shaft. An easier method is shown below. | ||
Latest revision as of 01:04, 21 January 2023
Optimal
- Try your best to cut corners as with all water stages.
- Klampon bounce; You need to roll very close to the edge of the platform, jump out of it as late as you dare and do a full jump. It's recommended to briefly let go and repress the d-pad right after the bounce to not go straight into the lava. An easier method is shown below.
- 0:13; Face left while exiting the water to spawn the klampon later so you can jump over it. an easier method is shown below.
- 0:23; don't buffer this roll, you could miss clapper and take damage.
- 0:31 try to avoid grabbing half-way, it causes a lot of lag, the roll over the gap right after can't be buffered.
- 0:40 try staying close to the surface on the ascend here. The Lockjaw's spawn position depends on the water level and kong's position. By staying close to the surface you can cut the corner a bit tighter.
- 0:50 wiggle down the shaft. An easier method is shown below.
